maxflo ?

[tie]

hey guys im have a question ... lets say u have a maxflo asa ... and u take off the tank ... what happens if u get dirt or paint inside the tank .. and then u put it back on and then u air it up ... will it **** up the gun or tank?

[Dr.Doom_machine]

Dont get paint or dirt inside your tank.... Or just leave the tank on....

That would be the simple solution.

[Flip]

What if there IS paint in it. i think he's asking.

Gotta find a way to clean it out.
Dirt and **** will go through the gunand mess up the noid

[kitchengod]

dont take the tank off if you get dirt inside the dirt could end up in your guns internals and **** it up.

[.matt.]

if you have access to a compressor and the air blower attachment...this is saying that there is dirt/paint in the tank....run a little bit of water into the tank and then use the air blower for between 1-3 minutes to get all the dirt, paint and water outta the tank and you'll be good...and before someone says it doesnt work i have done it and it does work

[bigred]

+1 matt. tie water doesnt hurt your tank, so use a bit of water to get all of the paint, dirt and debris out of your tank and dry it thoroughly, then use it