-
New Member
Loader not sitting on...
Well, I know its more of a general question and not cocker specific, but since its a Trilogy I might as well post here :P I was trying to get my 200 round generic loader onto the top of it, and wouldn't you know it, its a tiny bit too large diameter wise to fit in snugly, so I was wondering, if I shaved off a bit of the outer plastic on the loader, would this cause any problems with ball feeding or stabilty in the loader? The amount I'm looking at taking off is less then 1 mm around.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks